DVS Atomix LT Installation Guide download pdf (Page 54)

4-2

Atomix LT Installation Guide

Figure 4-1: Setting of Flash controller DIP switch

This setting will load a safe mode programming (fallback map) when

the PCI video board is initialized during start-up. Now use this fallback

map to perform the firmware upgrade once again:

 Close the casing of the computer system and plug in its power

cable(s).

 Turn on the computer system.

 After the start-up of the computer and the loading of the operating

system run the firmware upgrade program (atomixltup###, see

section “Upgrading the Firmware” on page 3-15) once again.

 When the upgrade program has finished the procedure, shut down

the computer.

You must now set the DIP switch for the Flash controller back to its de-

fault position:

 Disconnect the power cable(s) of the computer system.

 Open the casing of the computer system.

 Then set the DIP switch for the Flash controller back to its default

setting as shown in the respective figure in section “Overview of

the Soldering Side” on page 2-6.

 Close the casing and plug in the power cable(s).

 Now start the computer.

 After the operating system has loaded check the firmware version

as described in section “Determining the Firmware Version” on

page 3-14.

If the firmware version is upgraded, the procedure is finished.

Never operate the PCI video board with the fallback map en-

abled. Make sure that for normal operations the DIP switch is

set back to its default position.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 71 72

No comments

DVS Atomix LT Installation Guide Page 54