DVS Clipster User's Guide download pdf (Page 155)

7-17

The VTR Task Mode

7.2 The Settings

This section describes all settings possible during your work with the

VTR task mode. As with the other task modes of the I/O Tool, the set-

tings for the VTR task mode are performed in the selection area of the

I/O Tool (see section “Overview of the User Interface” on page 2-5).

After clicking on the button VTR the I/O Tool switches

to the VTR task mode and the selection area to the

right of the task mode buttons changes its appearance. Then you can

see the settings items that are provided for this mode. The following

figure shows the selection area as it appears in the VTR task mode:

Figure 7-10: Selection area of VTR task mode with a new timeline initialized

Most settings of the VTR task mode can be used in the same or a similar

way like the ones used for the other task modes of the I/O Tool. This

section explains all items available in the selection area of the VTR task

mode.

7.2.1 The Video Format

When the VTR task mode is activated and a VTR timeline is initialized

or loaded, you will be able to determine the video format settings for

an output of video signals, i.e. for a play-out. For this you have to use

the button VIDEO FORMAT… which will set the video output raster for

Before working with the VTR task mode you have to either ini-

tialize a new or open an already saved VTR timeline (see sec-

tion “Starting a VTR Task Mode Session” on page 7-3).

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 199 200

No comments

DVS Clipster User's Guide Page 155