DVS Clipster User's Guide download pdf (Page 305)

8-13

The Conforming Tool

y Once everything is set confirm your settings with the OK button.

This will start the creation process and a progress bar may inform you

about its status. When finished, the clips of the EDL will be available in

the timeline of the Edit Tool. If an EDL with unconformed events has

been added to the timeline, you will be asked whether you want to per-

form an autoconforming immediately:

Figure 8-5: Continue with autoconforming?

Then you can start the conforming process right away by confirming

the message with the OK button (see section “Conforming” on

page 8-13).

Alternatively, if you want to configure the EDL beforehand or record

the clips of the EDL from a connected external player, you can skip the

automatic conforming with the button CANCEL. Then you can process

the EDL either in the timeline directly (see section “Working with EDLs

from the Timeline” on page 8-22) or use the conforming mode of the

Edit Tool for further adjustments (see section “The Conforming Mode

in General” on page 8-25).

8.2.3 Conforming

As soon as an EDL is available in the Edit Tool, it can be conformed.

There are several ways to start an autoconforming:

– An autoconforming can be started manually, for example, with the

controls of the conforming mode of the Edit Tool.

– An autoconforming can be performed automatically right after the

build-up of an EDL in the timeline.

For an autoconforming the video/audio data must be already

available as files on a storage.

There are other possibilities at your disposal to conform an

EDL, such as the capturing of the required data from an exter-

nally connected player. For further information about these see

section “Working with EDLs from the Timeline” on page 8-22

and section “The Conforming Mode in General” on

page 8-25.

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 427 428

No comments

DVS Clipster User's Guide Page 305