8-41
The Conforming Tool
2
1
3
4
5
6
7
8
I
A
9
During the closing procedure you will also be asked whether you want
to save the EDL, i.e. whether already made changes should be saved as
an EDL. In case you confirm this, the procedure to export an EDL will
be initiated (see section “Export as…” on page 8-41).
Export as…
This button exports the selected EDL with all changes applied to an
EDL. It performs the same procedure as the menu option Export
EDL… of the Project menu but for the currently selected EDL only
(see section “Export EDL…” on page 9-8).
Duplicate
This button duplicates the selected EDL. Afterwards the duplicated EDL
will be available in the bin as well as on the tab EDLs (see section “The
Tab ’EDLs’” on page 8-29).
Print…
This button prints out the information of the currently activated tab of
the work area (see section “Conforming Mode – The Work Area” on
page 8-27). The elements that should be printed out can be adjusted
with the controls to configure the view of the conforming mode, such
as the button VIEW SETTINGS… (see section “View settings…” on
page 8-42) or the combo box Show (see section “Show” on
page 8-44).
8.6.2 The View Controls
The following describes the controls that allow you to determine the
view on the EDLs.
Figure 8-25: The view controls
<EDL>
From the drop-down list of this combo box you can select the EDL that
should be marked and/or displayed in the work area. The drop-down
Comments to this Manuals